beekeeb
  • Home
  • FAQ
  • Layout Testers
  • Keyboards with Cirque Trackpad
  • Allium58 Keyboard
    • Photo logs of installing Allium58 GLP 3D printed keyboard case
  • Cantor Keyboard
  • Chocofi Keyboard
    • Soldering a battery on a Chocofi Wireless
  • Dao Choc BLE Keyboard
  • DASBOB Keyboard
  • FelixKeeb
  • Ferris Sweep Keyboard
  • Hillside Keyboard
  • Hotreus62 Keyboard
  • keezyboost40
  • Piantor Keyboard
    • Quick Start Guide to Build a Piantor (Raspberry Pi Pico)
    • Quick Start Guide to Build a Piantor (WeAct RP2040)
    • Extra Firmwares
  • Pierce Keyboard
  • Stress Fight Pad
  • Swoop Keyboard
  • Thorium Keyboard
  • Yampad Keyboard
  • Zerosprey42 Keyboard
  • Raspberry Pi Pico and Other RP2040 Boards
  • Keyboard Build Guide
    • Avalanche v4.2 Photo Build Log
    • elephant42 Keyboard Photo Build Log
      • elephant42 QMK Firmware with VIA
      • Acrylic Case with Fabric Middle Plates for Split Keyboard Installation
    • Redox v1 (rev 1.0) Build Log
    • Sofle RGB v2.1 SofleKeyboard Photo Build Log
      • Extra Photos for Soldering the RGB LEDs
    • REVIUNG41 Case Installation
    • TOTEM Case Installation
  • Other Guides
    • How to Install display, battery and Test the Wireless Corne Keyboard
    • Installing a Battery to the Ferris Sweep v2
    • Adding nice!view to a Keyboard with a 4-pin OLED Compatible Shield with a Hidden Wire
    • How to Flash a Firmware to USB-C Controller
    • How to Flash a Firmware with OpenOCD
Powered by GitBook
On this page
  • Left Hand PCB
  • Indicator
  • Droplight (Underglow)
  • Per-key
  • Right Hand PCB
  • Indicator
  • Droplight (Underglow)
  • Per-key

Was this helpful?

  1. Keyboard Build Guide
  2. Sofle RGB v2.1 SofleKeyboard Photo Build Log

Extra Photos for Soldering the RGB LEDs

PreviousSofle RGB v2.1 SofleKeyboard Photo Build LogNextREVIUNG41 Case Installation

Last updated 3 years ago

Was this helpful?

There are two circles at the light emitting side. The smaller circle should be aligned with the silkscreen marking on the soldering side.

Left Hand PCB

Indicator

The small circle faces South.

Droplight (Underglow)

There are 6 LEDs. They do not have the same orientation.

Top Row: South - North - South

Bottom Row: North - North - North

Per-key

The small circle faces North.

Right Hand PCB

Indicator

The small circle faces North.

Droplight (Underglow)

There are 6 LEDs. They do not have the same orientation.

Top Row: North - South - North

Bottom Row: South - South - South

Per-key

The small circle faces South.

Front
Back
Front
Front
Back
Front